Upcycled LEGO Bracelet Craft – Step-by-Step Picture Tutorial

UPCYCLED LEGO & PLASTIC BAG BRACELET CRAFT

SUPPLIES

1 Plastic Bag (I use a small black one like you get for pet pickup or diaper bags)

1 Flat Lego (any color)

Wood Burner or Solder iron

Sharp Knife

DIRECTIONS

1. Lay the Lego pieces on a piece for cardboard. Take the wood burner or solder iron and melt a hole on the top about ¼ from the end of the Lego. Do the same on the other end. You may need to move the burner around a little to make the hole bigger. Take a the knife (I use an X-Acto knife) and scrap the inside of the hole and any ruff edges from where you melted the holes.

Now we want to make the band. For this we will cut of the end of the bag that is sealed. Then lay the bag flat and fold it, as it is easier to cut this way. Cut it into about ¼ inch pieces. Make sure when you cut it that you do it cross ways and not the length of the bag. Now take the cut pieces and open them up.

Take one piece and run it through another and then back through its self so that they are locked together. Then add another piece to that one. You should now have 3 pieces locked together. Make three of the three piece chains. Tie one end so that all three pieces are tide together. Now you will braid them, crossing one piece over the other until you have made it all the way to the end. Repeat this to make two more braids so that you have a total of three braids.

Then take all three brads and tie them together at one end and brad them all together. Put a tight knot at each end of the finished brad and cut off the fringe side of the knot so that the braid it still intact.

Now looking at the top of the Lego, feed one end of the braid down through the hole and then back up through the other hole. Place on wrist and tie the two ends of the brad together. There you have it, a nice plastic bag Lego bracelet!

 For more fabulous ideas, check out my

Ultimate LEGO Birthday Party Planner!